How to source Starter Vape Kit carton specs glossary

Getting the documents right

There is no shortage of suppliers quoting starter vape kit. The scarce thing is a supplier who will tell you which SKU to drop. We have been shipping starter vape kits long enough to know that the honest answer is usually a shorter list, and that is the answer we give.

If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.

Regulation for starter vape kits differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.

After-sales, replacements and reorders

The replacement policy is deliberately simple: report within seven days of delivery with photos and the batch code, and we replace or credit at the next shipment. We do not argue about a defect we can see in a photograph.

Returns are handled as data, not as complaints. Every reported failure is logged by mode and by batch, and the pattern is reviewed monthly with the factory.

Unit price versus landed cost

The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.

We publish a realistic band of 2.84 to 8.60 per unit for standard configurations at 50 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.

• Seven-day defect reporting with replace-or-credit
• Consolidated or split shipping, quoted both ways
• Specification locked in writing before production starts
• Batch codes traceable from carton back to production date
• Document pack prepared per destination market
• Artwork proof plus physical dummy for custom packaging

Quality control, in plain terms

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.

Specification summary

The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz